Service
Water Heater Service, Repair & Replacement
A water heater rarely fails without warning. It gets slower to recover, noisier, or starts leaving rust in the hot side long before it leaks. Catching it at that stage is the difference between a planned replacement and a flooded utility closet.
- Homes
- Commercial
- Multifamily
Water heaters are the single most common source of interior water damage in occupied buildings, and almost every one of those failures was visible months earlier as a performance change rather than a leak.
That is the whole argument for treating hot water as a maintained system rather than an appliance you replace when it dies.
Warning signs
- Hot water runs out faster than it used to, or takes longer to recover between uses
- Rumbling, popping or kettling sounds from the tank
- Rusty or cloudy water on the hot side only
- Water pooling under or around the unit, or staining on the pan or floor
- The temperature-and-pressure relief valve discharging
- A tankless unit short-cycling, error-coding, or delivering inconsistent temperature
- A unit past its expected service life, especially in a finished or occupied space
What RePlumbify inspects and performs
- Diagnose no-hot-water and inconsistent-temperature complaints on tank and tankless systems
- Repair or replace thermostats, elements, gas control valves, igniters and relief valves
- Replace tank water heaters, including code-required seismic strapping, expansion control and venting
- Install and service tankless units, including descaling and flushing
- Service recirculation systems, pumps, timers and dedicated return lines
- Replace or install expansion tanks and pressure-regulating valves where required
- Flush and inspect tanks, and replace sacrificial anode rods, as scheduled maintenance
What to expect
- You tell us the symptom and the unitA photo of the data plate saves a visit's worth of guessing — it tells us fuel type, capacity, age and venting.
- We confirm a service windowRequested windows are proposals until dispatch confirms them.
- We diagnose before quotingA failed thermostat and a failed tank cost very different amounts. We establish which one you have.
- You approve repair or replacement in writingIf replacement is the recommendation, you get the reasoning: age, condition, failure mode, and what a repair would realistically buy you.
- We install to code and document itSeismic strapping, expansion control, venting, relief-valve discharge and combustion air are part of the job, not extras.
Residential and commercial
For homes and condominiums. For a home, the two decisions that matter are tank versus tankless and where the unit lives. A tankless conversion is not automatically the better answer — it depends on gas line capacity, venting, fixture demand and how the household actually uses hot water. We will give you the honest version rather than the upsell.
For commercial and multifamily buildings. For multifamily and commercial buildings, hot water is a habitability and an operations issue. We can inventory units by building, document age and condition, and put replacements on a planned schedule instead of an emergency one.
Questions
Water Heaters — frequently asked
How long should a water heater last?
It varies widely with water quality, maintenance history and how hard the unit works. Rather than quoting an average, we look at the specific unit — anode condition, sediment, corrosion at the fittings, and the failure mode you are describing — and tell you where yours actually is.
Is tankless worth it?
Sometimes. It depends on your gas supply, venting path, simultaneous fixture demand and how long you plan to keep the property. It is a genuinely better answer for some buildings and an expensive lateral move for others. We will tell you which one you have.
Can you replace a water heater in an upstairs closet or over finished space?
Yes, and those installations are exactly where pan, drain, leak detection and correct expansion control matter most, because the failure mode is water in the ceiling below.
Do you service the unit I already have, or only replace it?
We repair and maintain as well as replace. Flushing, anode replacement and descaling on tankless units meaningfully extend service life, and that is cheaper for you than a replacement cycle.
Related
You may also need
Plumbing Repairs
Repair work for the failures that stop a building from functioning — leaks, drips, low pressure, failed shutoffs and fixtures that will not hold.
Learn morePreventive Plumbing Maintenance
Scheduled inspection and maintenance that converts unplanned plumbing emergencies into planned, budgeted line items.
Learn moreRepiping
Replacing the water distribution piping in a building rather than repairing the same system again — planned, phased and documented.
Learn more