Fixtures, Faucets & Toilets

Fixtures are the part of the plumbing system people actually touch, and they are also where deferred maintenance is most visible to a tenant, a guest or a buyer.

They are also where small, cheap interventions have outsized returns: a rebuilt toilet, a replaced cartridge, a new angle stop. None of it is dramatic work. All of it prevents the dramatic work.

Warning signs

• A toilet that refills on its own, runs intermittently, or never fully stops
• A faucet or shower valve that drips after being shut off, or will not hold temperature
• A shower that runs hot or cold when another fixture is used
• Water at the base of a toilet, or a toilet that rocks when you sit on it
• Corroded or seized angle stops under a sink or toilet
• A garbage disposal that hums, leaks at the housing, or trips its reset repeatedly
• Commercial flush valves that will not seal, or hands-free sensors that misfire

What RePlumbify inspects and performs

• Repair and rebuild toilets — fill valves, flappers, flush valves, supply lines and wax seals
• Reset, replace and re-seal toilets, including flange repair where required
• Repair and replace faucets, cartridges, shower and tub valves and diverters
• Replace angle stops and supply lines during any fixture change, as standard practice
• Install sinks, tubs, showers, laundry connections and garbage disposals
• Service commercial flush valves, sensor faucets and restroom fixture groups
• Handle high-volume fixture replacement for unit turns and restroom refits

What to expect

1. 01You tell us the fixture and the symptomA photo of the fixture and the shutoff underneath tells us most of what we need to bring the right parts.
2. 02We confirm a service windowRequested windows are proposals until dispatch confirms them.
3. 03We diagnose on siteMany fixture problems are a worn part rather than a failed fixture. We will tell you which one you have.
4. 04You approve repair or replacementIn writing, before the work starts. If you are supplying your own fixture, tell us before the visit.
5. 05We complete and testThe fixture is installed, tested under pressure, and the work area is left clean.

Residential and commercial

For homes and condominiums. If you are supplying your own fixture, tell us the model in advance. Some designer and imported fixtures use non-standard rough-in dimensions or proprietary cartridges, and finding that out on site costs you a second visit.

For commercial and multifamily buildings. For unit turns and restroom refits, fixture work is a volume and scheduling problem. We can work from a standardised fixture specification per property so every unit gets the same parts, which makes future maintenance dramatically simpler.